Do you want your kids to be concious of washing their hands before they eat their Halloween candy? Here's a darling little antibacterial soap holder that we made at the club meeting.
We will be making the center one. The one on the right is made with basic black card stock and it's run through the Textured Impressions Spider Web Embossing Folder (120889, page 6 Holiday Mini 2010)
Stamp Set: Halloween Hoot (111582, page 23)
Card Stock: Pumpkin Pie, Basic Black, Whisper White, Nite Owl Designer Series Paper (123012, page 9 Holiday Mini 2010)
Ink: Basic Black
Embellishments: 1/2" Raven Lace Trim )120988, page 8 Holiday Mini 2010)
Punches: Scallop Oval (119856, page 200), Large Oval (119855, page 2020), Small Oval (119863, page 202), Bitty Bat (119279, page 200)
Here's a little tutorial to walk you through the steps
Step 1. Cut two pieces of card stock 10" x 3" and 6" x 1 1/2"
Step 2. Score the 10" x 3" at 1", 2" 5 1/2" and 6 1/2"
Step 3. Score the small piece along the long side at 1/2", 1 1/2", 4 1/2", and 5 1/2". Turn it and score along the short side at 1/4" and 1 1/4". Using a bone folder, fold over all the lines to make them nice and crisp.
Step 4. Cut off the tabs as shown in the picture
Step 5. Using your Large Oval punch, cut out an oval in the center of the 6" x 1 1/2" piece - cut the oval and then cut just another smidge to fill the entire center area
Step 6. Apply Sticky Strip to the top, bottom and side tabs of the 6" x 1 1/2" piece (above picture)
Step 7. Fold the 10" x 3" piece on the score lines
Step 8. Add the 6" x 1 1/2" piece to the bigger piece by folding the tabs and sticking them to the 2nd 1" strip
Step 9. Fold up the bottom inch and stick to the sticky strip
Step 10. Now fold the insert up and apply to the back of the big piece
Step 11. Your little bottle of antibacterial hand soap will now fit tightly into the oval. The nice thing is that it won't fall out!!
Step 12. Apply the designer paper to the outside and inside of your soap holder. I cut the basic black 3 1/4" x 2 3/4" and the skull designer paper 3" x 2 1/2". I applied the Raven lace trim on the front before adhering it to the soap holder. The adhesive does not stick to the lace trim, so I put some adhesive on the back and stretched the ribbon around. The sentiment and the bat are applied with dimensionals
Step 13. I applied the dsp to the inside top of the soap holder (cut 3 1/4" x 2 3/4") and the front (cut 2 3/4" x 3/4"
To order products to replicate this project from Stampin' Up 24/7 click here
Comments
You can follow this conversation by subscribing to the comment feed for this post.